User’s Manual
Rev1.0
Date:15/07/2015 User’s Manual
20
/
47
Picture 5.1 enter and quit code setting
When in code setting, the first row will display the reference number of the code setting, and the
lower row will display the contents of this parameter. The digit that is flashing is the digit under
setting. Please reference to picture 5.2, which means C01=02, that is set the pre-heating time to 2
seconds.
Picture 5.2 code setting
When under code setting, Now ,user can use “L-R button” to choose which digit on the displayer
are to be set , and use “R-D button” to switch the digit to 0~9 . The first time of pressing “Enter
button” means to set the lower row, when under this situation, users can still use “L-R button” or
“U-D button” to set. Press “Enter button” again to check if the setting is available. If setting is
available, the display will not flash, when user can still press “L-R button” or “U-D button” to set
again. When display is not flashing, pressure “Enter button” to save and go to next setting.
If want to quit code setting, same as entering, please hold “Enter button” then press “U-D button”
at the same time.
5.1.2 Digital setting
Under working status, to enter code setting, please hold “Enter button” then press “L-R button” at the
same time. Please reference to picture 5.3.
