Nitto Seiko FF503H, Instruction Manual

Page: 47 / 61

Vibratory Track Screw Feeder FF/FM503H ver2
37
(Example) When the software version is 01.23, indicating status of the LEDs is as shown below.
3
4
1
2
3
4
2
1
3
4
1
2
3
4
1
2
0 1 2 3
1
2
3
4
x
1
2
3
4
x
1
2
3
4
x
1
2
3
4
x
Repetition
1s 1s 1s 1s 1s 1s 1s
Indication start
3s
(CAUTION)
To finish the version check mode, shut off the power supply.
9. Maintenance and check
WARNING Ensure that the power and air supply are shut down before adjustment,
maintenance, or inspection of the machine. Before restarting it after a long interval,
completely clean and check it, and perform a test run to ensure that it is free from
any fault.
Otherwise, electric shocks, accidents, or malfunctions may occur.
CAUTION After a maintenance, check or adjustment operation is over, be sure to put back the
tools you have prepared and used in the box they were in.
If you leave the tools on the machines or the floor around you, accidents or malfunctions
may happen.
Perform maintenance of the following items. The indicated “maintenance cycles” are rough standards. Increase
or decrease the cycles as necessary judging from the use conditions and environments as necessary.
9.1. Filter regulator
Check if there is water collected inside the filter regulator every day
before starting operation. Drain the water if found.
9.2. Lubricator
In order to keep the oil surface at or above the lowest limit inside the
bowl of the lubricator, add the oil periodically. If the oil does not drop
properly, a problem with lubrication may happen in the target machine.
Check the lubricator for the amount of oil drops every day before
starting operation.
9.3. Inside the FF/FM503H
If oil or dust is attached on the track, basket, hopper track, or escapement unit, remove it with a cloth etc.
carefully. Otherwise, a trouble with screw supply may happen.
CAUTION Be careful not to cut or rub your hand or finger.