Vibratory Track Screw Feeder FF/FM503H ver2
3
2.3.
Designations of components
2.3.1.
Front face
Fig.3
Fig.4
(1) Setup panel
This panel is intended for indication of power ON and setup
and display of modes and parameters.
(2) POWER LED
This LED lights up when the power is supplied. (Color:
Green)
(3) Controller status LEDs
These LEDs indicate the status of controller. (Color:
Orange
)
They indicate the setup statuses while the machine is in the
setup or adjustment mode.
(For details, refer to
“8. Setup procedures”.)
(4) Setup keys
Any intended functions or setup values could be selected with
these keys while the machine is in the setup mode.
[
]: UP key (Item number is increased by one, setup value is
increased by one)
[
]: DOWN key (Item number is decreased by one, setup
value is decreased by one)
[
]:
ENTER key (Confirmation of item number or change in
setup value)
(5) Screw feeding receptacle (3P) (CN FEED) (Hand driver
type)
This receptacle is intended for connection of the screw feeding
signal cable for the hand driver type. It is not provided for the
automatic type.
(6) Air supply port for air driver (Hand driver type)
This air supply port is intended to supply air to the hand driver
tool (air driver).
(7) Escapement unit
This unit feeds screws by compressed air.
2.3.2.
Back face
Fig.5
(8) Power switch (SW1)
This switch turns ON/OFF the FF/FM503H.
(9) Fuse (Contained in fuse holders FU2 and FU3)
0215004. MXP made by Littelfuse
(5 × 20 mm 250 VAC 4 A time lag type complying with RoHS)
(10) AC inlet (NF1)
Our specified AC input power cable should be connected to
this inlet. Connect the plug of the AC input power cable to the
specified receptacle. (For details, refer to
“For safe use”.)
(11) External I/O receptacle (CN IO) (9P)
This receptacle is intended for connection of our specified
external I/O plug (or external I/O cable) for automatic type.
Connect the other end of the external I/O cable to the
programmable logic controller (PLC) etc. stored in the separate
external controller (to be prepared by customers). (This
receptacle is not attached to the hand driver type. However, it
can be attached optionally.)
Summary of Contents for FF503H
Page 60: ...Memo...
