Vibratory Track Screw Feeder FF/FM503H ver2
34
POWER
4
3
2
1
FEED.
VIB.
FREQ.
RUN
LED 1 to 4
8.3.3.1. Parameter initializing mode
Operation parameter and equipment parameter are initialized in this mode. After initialization is finished,
parameters are the same as the defaults shown in the tables of “8.3.1 Operation parameter setup” and “8.3.2
Equipment parameter setup”.
For the operating procedures to enter into the parameter initialization mode, refer to
“8.2.3 FF/FM503H
Setup and adjustment mode function list”.
When the parameter initialization is completed, LEDs from LED1 (=1 FREQ.) to LED4 (=4 RUN) flash.
To finish the parameter initializing mode, shut down the power.
Caution: If the initialization is performed, the machine cannot
be operated correctly unless parameters are set up
again depending on the type of FF/FM503H and
status of equipment.
Do not perform this operation except in special cases
such as replacing the “FF/FM503H-MAIN-R PCB”
after removing the cover of the main body.
8.3.3.2. I/O check mode
WARNING
This operation includes functions such as energization/de-energization of the
solenoid valve incorporated in FF/FM503H.
Since screws may be fed depending on the operation, you may lose your sight or suffer
from injuries. Perform the operation after fully understanding the descriptions in
“For safe use”.
In this mode, input and output (inside and outside) of FF/FM503H can be checked.
Input signals can be checked by the LEDs on the setup panel, and output signals can
be checked with using the key switches. For operating procedures required in order
to enter the I/O check mode, see
“8.2.3 FF/FM503H Setup and adjustment
mode function list”.
(1) Input check
When input signals are turned on, corresponding LEDs in the table below light up. Use the LEDs to
check input signals as necessary.
The following table shows LEDs that light up according to input signals. Note that you cannot check
correctly, if some input signals are set to the “ON” status.
Lit up
LEDs
Input signals
LED4 Lit up in I/O check mode regardless of input signal
LED3
Hopper lower
limit detection
Screw feeding
signal (automatic
type)
Screw feeding
signal (hand
driver type)
♦
Operation enable
signal
(screw
taking-out type)
(Note 1)
LED2
Basket inside
residual
detection
(Note 1)
Optional sensor
(Note 2)
Screw feeding
signal (automatic
type)
Operation enable
signal
(screw
taking-out type)
(Note 1)
2
3
4
1
F-1
4
1
2
3
Ｆ
1
4
3
2
1
4
3
2
F-2
1
2
3
4
4
1
2
3
Ｆ
Summary of Contents for FF503H
Page 60: ...Memo...
