Vibratory Track Screw Feeder FF/FM503H ver2
4
(12) a. Air supply port (for the automatic type)
b. Air supply port (for the hand driver type or (13) attached
optionally)
Connect the air tube with 8 mm outer diameter.
(13) Filter regulator
Set this regulator to the specified pressure. This filter regulator
is not attached to the automatic type. However, it can be
attached optionally.
(14) Lubricator
This lubricator supplies lubricating oil to the hand driver tool.
It is not attached to the automatic type and the hand driver type
of electric driver specification. However, the lubricator can be
attached optionally.
(15) 3P receptacle for connecting SH300 (CN SH)
This is a 3P receptacle for connecting the optional rotary drum
auxiliary hopper SH300.
3. Installation of FF/FM503H
3.1.
Operating environment
WARNING
Satisfy the conditions required for the operating environment.
Otherwise, fires, electric shocks, accidents, or malfunctions may occur.
For the operating environment, refer to
“Preface”,
“For safe use”, and
“12.1 Specifications”.
3.2.
Installation
Install the FF/FM503H on a solid and horizontal floor (or table) so that screws can be fed from the top face,
setup can be carried out from the front face, and the power switch can be operated from the back face, for
correct vibration to be performed for screw alignment (see the figure shown below). Installation of the
machine onto the place where measures against vibration are provided or onto a slope may cause troubles in
screw feeding. Provide some measures against tipping or dropping, if necessary.
CAUTION
Do not remove the rubber foot to fix the unit directly on a surface.
Otherwise, the straightforward rail may not be vibrated enough to feed the screws properly.
Fig.6
Summary of Contents for FF503H
Page 60: ...Memo...
