Nitto Seiko FF503H, Instruction Manual

Page: 31 / 61

Vibratory Track Screw Feeder FF/FM503H ver2
21
Table 1. Standard clearances
Symbol Location Clearance [mm]
A Clearance between frame and hopper track 0.1
B Clearance between hopper track and fixed track 0.1
C Clearance between fixed track and track 0.4
D Clearance between track and screw receiving plate 0.6
E Clearance between hybrid holder and top plate 0.3
Cautions: The clearances shown in the table above are standard values.
It is necessary to make adjustments depending on the shape of a screw and the
vibration, frequency, vibration strength, etc. of the vibrator.
8. Setup procedures
CAUTION
Setup and adjustment works described in this section have direct influence on the
operation of FF/FM503H.
Even if change in the setup is within the range setup and adjustment are possible, correct
operation is disabled unless the setup and adjustment is appropriate. Fully understand the
functions before the setup and adjustment.
Functions of FF/FM503H are limited in the setup and adjustment mode. In such a status,
screw feeding may not be carried out correctly.
All the parameters have been setup optimally before delivery. When readjustment is required, operate the setup
panel as shown below.
8.1. Setup panel
8.1.1. Appearance of setup panel
Appearance of setup panel is as shown in the figure
on the right side.
POWER
4
3
2
1
FEED.
VIB.
FREQ.
RUN
LED 1 to 4 Keys
POWER
LED
8.1.2. Functions of setup keys
Functions of setup keys on the setup panel are as shown in the table below.
Keys Designations
Functions
UP key
• Setup item number can be selected (item number is increased by one)
• Setup value of selected item can be changed (setup value is increased by a step)
□
↓
DOWN key
• Setup item number can be selected (item number is decreased by one)
• Setup value of selected item can be changed (setup value is decreased by a step)
□
↲
ENTER key
• Selected item number can be confirmed.
• Altered setup value can be confirmed.