Vibratory Track Screw Feeder FF/FM503H ver2
36
Note 2: To be used for optional type.
Note 3: To be used for optional (special) type.
(Notes)
1) The “+” sign shown in the table above indicate simultaneous pressing of keys. For example, “
+
” keys means pressing of the “
” key while pressing the “
” key.
2) Pay extreme attention to output signal to be output corresponding with the keys pressed while some
keys are pressed. (For example, when you try to output the signal indicating the lack of screw on the
track with using the “
+
” keys, the signal corresponding with the “
” key is output, until “
+
” key operation becomes effective after the “
” key is pressed.)
3) To finish the I/O check mode, shut down the power supply.
8.3.3.3. Version check mode
In this mode, software version of the PCB (FF/FM503H-MAIN-R) in the main body can be checked.
The software version is indicated by four-digit number.
3
4
1
2
F-3
1
2
3
4
4
1
2
3
Ｆ
After this operation is finished, each of the LEDs from LED1 (=1 FREQ.) to LED4 (=4 RUN) on the setup
panel indicate the statuses shown below.
Indication start
Repetition
Correspondence of the indicating statuses of the LEDs with the indicated numbers is shown below.
The “x” shown below indicates the status of all the unlit LEDs for the separation between numbers.
4
1
2
3
3
4
1
2
3
4
2
1
3
4
1
2
3
4
1
2
4
1
2
3
4
2
1
3
4
1
2
3
3
1
2
4
3
2
1
4
1
2
3
4
0 1 2 3 4 5 6 7 8 9
x
｢ ｣
8
｢ ｣
4
｢ ｣
2
｢ ｣
1
LEDs
from 1 to 4,
all unlit
(for 3 sec.)
Fourth
digit lit up
(for 1 sec.)
LEDs
from 1 to 4,
all unlit
(for 1 sec.)
Third
digit lit up
(for 1 sec.)
LEDs
from 1 to 4,
all unlit
(for 1 sec.)
Second
digit lit up
(for 1 sec.)
LEDs
from 1 to 4,
all unlit
(for 1 sec.)
First
digit lit up
(for 1 sec.)
Summary of Contents for FF503H
Page 60: ...Memo...
