FORM NO. 56043058 Hydro-Retriever™ 3800 / 2042 / BR 1100 -
27
SCRUB BRUSH SYSTEM
FIGURE 9
SCRUB BRUSH DECK LEVELING ADJUSTMENT (CYLINDRICAL)
1
See Figure 9. On a level floor surface put the scrub deck in the raised (stored) position and measure the distance from the floor to the bottom
edge of the scrub deck at all Four Corners as shown.
2
The four measurements should be approximately 2-1/2 inches (64 mm). To adjust, loosen the Lock Nuts
(M)
on the (4) Connecting Rods
(L)
and turn the center section of the rod(s) to raise or lower (lengthen or shorten) the levelness of the brush deck.
Note:
The assembly
length on the ball joint connecting rods are adjusted to 5 inches (127 mm) from ball joint to ball joint as shown in Figure 9.
3
Re-tighten the connecting rod lock nuts and lower the brush deck to the floor and check for an even brush pattern.
revised 12/02
2-1/2
"
( 1/8
"
)
64 mm ( 3 mm)
1/2
"
to 9/16
"
(12-14 mm)
5
"
(127 mm)
9-1/4
"
(235 mm)
I
L
M
