50
- FORM NO. 56043058 Hydro-Retriever™ 3800 / 2042 / BR 1100
REAR WHEEL SYSTEM
Splined Shaft
FRONT
Tire
Brake Arm (D)
Frame Stop
Inside View of
Left Rear Wheel
Axle
Left Wheel Shown
INSTALLATION OF BRAKE SHOE ASSEMBLY
1
See Figure 1. Start with the Brake Arm
(D)
attached to the Brake Equalizer Bar
(J)
. Next install the Brake Shoe Assembly
(H)
and rear wheel
hub assembly onto the axle shaft.
2
See Figure 2A. From the back side of the wheel grip the splined input shaft with a locking pliers and turn it CW (clockwise) for the left wheel,
to set the brake shoe linings to the wheel drum.
Note:
For the right wheel, turn the splined shaft CCW (counter clockwise).
3
See Figure 2B. Hold the brake input shaft firm and at the same time install the brake arm to the splined shaft also having the backside of
the arm contacting its “frame stop” (as shown). Note: These assembly steps are important so both left and right arm angles are adjusted
to provide equal shoe to drum contact. To achieve proper wheel brake engagement and pedal travel.
4
Next install the brake arms pinch bolt and tighten to secure the arm to the shaft. Then spin rear wheel by hand and press brake pedal to
check that the wheel stops. Note: See brake cable adjustment if pedal has more than 1 inch of travel to start full brake engagement.
5
Lower machine and retighten the wheel hub retainer Bolt
(A)
and also test drive machine to check for correct service brake and parking brake
functions.
FIGURE 2A
FIGURE 2B
revised 12/02
