14
1 - T5ETL-1K AND T7ETL-1K OPERATOR INSTALLATION (Continued)
1.8 - Learning and Limit switch adjustment (continued)
3. Move the gate manually (with your hands) to ensure that the gate travels to the fully open and fully
closed positions with no binding or problems. Gate should move freely. The control board is al-
ready in the “LEARNING MODE” when shipped. If not 10 in learning mode press FUNCTION then
press LEARN then press SWING then press LIGHT, AVERAGE OR HEAVY, then press ENTER.
4. Manually move the gate mid-way and engage mechanical release and stow handle (see Figure 17
T5/T7 MANUAL ENGAGE). Test motor direction by pressing OPEN. If the gate instead CLOSES
swap the RED and BLACK motor leads shown in Figure 13 T5/T7 MOTOR WIRING DIAGRAM.
Using the OPEN button on the front of the Control board, hold the button down until the gate
reaches the fully intended open position.
Figure 18 - T5/T7 LIMIT SWITCH ADJUSTMENT
5. Adjust the Open Limit Switch (See Figure 18) until the GREEN light illuminates on the front of the
control board (See Figure 19). The FULLY OPEN limit switch is now set.
Figure 17 - T5/T7 MANUAL ENGAGE
USE 13 mm METRIC SOCKET
