9
1.3 - Removing the Top Cover
Refer to Figure 6 TOP COVER REMOVAL. Locate the top cover on the T5/T7 and remove the
two Phillips-head screws by rotating them counter-clockwise to access the mounting hole and
the wiring connectors. Be careful to retain the screws and cover for reinstallation once the T5/T7
is installed, the gate controller is programmed and any other mechanical or electrical adjust-
ments have been made.
1 - T5ETL-1K AND T7ETL-1K OPERATOR INSTALLATION (Continued)
1.4 - Attaching the operator to the pivot bracket and attachment
While resting the front end of the gate operator on the gate attachment bracket, slide the back
end of the gate operator onto the installed pivot bracket as shown in Figure 7 ATTACHMENT
TO THE PIVOT BRACKET. Insert the bolt, washer, and locknut as shown in the diagram. Be
careful to not to over tighten the locknut, but the bolt should be sufficiently tightened to securely
fasten the gate operator to the pivot bracket.
Figure 6 - TOP COVER REMOVAL
Figure 7 - ATTACHMENT TO THE PIVOT BRACKET
