Nibe AMS 10-16, Installation And Maintenance Instructions Manual

Page: 6 / 104

Information about the installation
Product information
NIBE SPLIT is a complete modern heat pump system that
offers effective energy saving and reduced carbon dioxide
emissions. NIBE SPLIT gives safe and economical climate
control.
The heat is retrieved from the outdoor air through an
outdoor module (AMS 10-16), where the refrigerant, which
circulates in a closed system, transfers the heat from the
heat source (outdoor air) to the indoor module (HBS 16).
This eliminates the need for bore holes and coils in the
ground.
Features of NIBE SPLIT
႑
Optimal annual heating factor thanks to the inverter
controlled compressor.
႑
Outdoor unit with compact dimensions.
႑
Speed controlled circulation pump.
႑
Optimized operating costs. The speed of the compressor
is adjusted according to the demand.
႑
Supplemented with tanks HE 30, HEV 300 or HEV 500
for indoor module HBS 16 and outdoor module AMS
10-16.
႑
Integrated clock for scheduling extra hot water and
temperature lowering/increasing the flow line temper-
ature.
႑
Prepared for control of two climate systems.
႑
Integrated active cooling function.
႑
Possible to connect external heat sources.
Principle of operation NIBE SPLIT
System without hot water, only heating (cooling)
2YHUIORZ YDOYH
BT 1
RG10/
RE10
Överströmnings-
ventil
CP1
AMS 10-16
HBS 16
HE 30
2YHUIORZ YDOYH
2YHUIORZ YDOYH
+%6
$06
System heating (cooling) and hot water
BT 1
RG10/
RE10
Erf. säker-
hetsutr.
FL1
FQ1
Överströmnings-
ventil
CP1
HBS 16
HEV 300/HEV 500
AMS 10-16
2YHUIORZ YDOYH
5HTXLUHG VDIHW\
HTXLSPHQW
2YHUIORZ YDOYH
Function
NIBE SPLIT is a system that can produce heating, hot water
and cooling.
The principle during heating can be simplified as follows:
1.
The refrigerant in AMS 10 retrieves heat from the
outdoor air then compresses it, which increases the
temperature further.
2.
The hot refrigerant (now in gas state) is routed into
HBS 16.
3.
The refrigerant releases the heat for further distribu-
tion in the system.
4.
The refrigerant (now in liquid state) is routed back to
AMS 10 and the process is repeated.
By reversing the process, thereby allowing the refrigerant
in AMS 10 to retrieve the heat from the water and release
it into the outdoor air, the heat pump can, if necessary,
cool instead.
HBS 16 determines when AMS 10 is to work and not to
work, using the collated data from the temperature sensor.
In the event of extra heat demands, HBS 16 can connect
additional heat in the form of the internal immersion
heater, or any connected external addition.
NIBE™ SPLIT 4
For Home Owners
Information about the installation