Nibe AMS 10-16, Installation And Maintenance Instructions Manual

Page: 28 / 104

Dockings
General
NIBE SPLIT can be connected in several different ways,
some of which are shown on the following pages. For more
detailed docking descriptions, see www.nibe.eu.
Installation requirements
AMS 10-16
0.25 MPa (2.5 Bar) Max pressure, climate system
+65 °C Max temperature, climate system
+65 °C Max temperature in HBS 16
+65 °C Max temperature from external heat source
+58 °C Max flow line temperature with compressor
+7°C/+18°C Min supply temperature cooling, HBS11-16/HBS 10-16
+25 °C Max supply temp. cooling
150 l Min volume, climate system during heating, cooling*
150 l Min volume, climate system during under floor cooling*
0.79 l/s Max flow, climate system
0.39 l/s Min flow, climate system, at 100% circulation pump speed (defrost flow)
0.24 l/s Min flow, heating system
0.32 l/s Min flow, cooling system
HEV 500 HEV 300 Docking external addition
9–27 kW Output external addition
0.17–0.33 l/s Recommended docking flow
* Regards circulating volume.
External circulation pump must be used when the pressure drop in the system is greater than the available external pressure.
In such cases, a bypass line with non-return valve must be installed.
Overflow valve must be used if min. system flow cannot be guaranteed.
Symbol key
Meaning Symbol
Venting valve
Shut-off valve
Non-return valve
Control valve
Safety valve
Temperature sensor
Expansion vessel
Pressure gauge
P
Circulation pump
Shunt / shuttle valve
Fan
NIBE™ SPLIT 26
For the Installer
Pipe installation