110
4.
BASIC OPERATION
MULTIFUNCTION GENERATOR
c) Trigger burst setting screen
■
1st page: Screen for the basic parameters
These are the common setting items that are common to all the oscillation modes.
Oscillation start/stop phase [Phase]
This is the phase at which oscillation starts and stops.
■
2nd page: Screen for the trigger burst settings
Mark wave number [Mark]
This is the wave number for oscillation each time a trigger is received. It can be set in
0.5-cycle units.
Stop level [StpLvl]
This is the signal level during oscillation stop. The level can be set to either off or on.
Normally, it is set to off.
)
p. 112
Trigger [Trig]
This is the trigger condition. Internal and external can be chosen as the trigger source.
)
p. 111
Trigger delay [TrigDly]
This is the trigger delay time. Upon receipt of a trigger, oscillation starts following the
lapse of the specified time.
)
p. 111
Sync out [SyncOut]
This is the output signal from the sync/sub-output terminal. Waveform reference phase
synchronization and burst synchronization can be chosen from.
)
p. 111
d) Waveforms for which trigger burst is not possible
Trigger burst is not possible for noise and DC.
e) Setting items required for trigger burst
On the 1st page of the setting screen, set [Phase] (oscillation start/stop phase).
On the 2nd page of the setting screen, set [Mark] (mark wave number). Normally, the wave
Set the oscillation
mode to [Burst].
Press the NEXT
key to display
the 2nd page
Oscillation start/stop
phase setting
Indicates that the 1st page
is displayed
Mark wave number
Press the NEXT
key to display
the 1st page
Stop level
Indicates that the 2nd
page is displayed
Trigger
Set burst mode to
[Trigger]
Sync output
Trigger delay
