46
will normally be burned off when the air wash vent is opened all the way and a fire is burning
briskly in the stove.
Warning
:
Do not exceed the maximum fuel load stated in these instructions
and do not over fire the stove.
If it is necessary to clean the glass more thoroughly, we recommend using an approved stove glass
cleaner, generally available from your stove retailer. (Follow manufacturer’s instructions).
4.5.3 Cleaning and checks inside the firebox
.
(User)
Inner firebox:
Brush the inside of the firebox clean from time to time to check the integrity of the
plates and liners etc. See section 3.1.3 for details of removeable parts of the stove. It is not
normally necessary to paint inside the firebox due to the high temperatures that mean that the paint
does not have much effect before being burnt off.
The vermiculite firebox side and back brick linings may require replacement occasionally
depending upon fuels and the type of usage experienced. If the firebox side or back linings are
damaged or worn replace with manufacturers recommended parts, it is essential that the cast iron
behind the side and rear bricks is not exposed to the fire. Side and back brick linings are not
covered by warranty, as they are a wearing consumable part.
Baffles:
It is essential
to check both top baffles for buildup of soot and ash regularly
irrespective if the stove has been used or not used. From time to time remove the baffles, to ensure
that the flue way entrance is completely clear. Baffle plates will require replacement from time to
time and are a wearing consumable part.
Visual checks
: Make visual checks to the inside and outside of the stove if any other items are
found to be worn damaged or cracked consult a suitably approved stove installer and do not use
the stove until any fault is rectified.
Stove controls
: Check the stove controls for full and free movement if any ash or debris is
restricting the use of the controls, clean as necessary.
Air Supply:
It is essential to check any air supply ventilator in the property is fully clear and open
if installed.
4.5.4 External surface cleaning
(User)
The steel and cast surface of the Windermere 5 SE stove is painted with black heat-resistant paint.
It is best maintained by simply vacuuming it with a soft brush attachment or wiping it down with a
dry, dust-free cloth, but only when the stove is not in use & fully cold.
If the stove is used too vigorously, the painted surface may assume a grey tinge over time, but the
stove can easily be freshened up with an approved heat resistant spray paint which should be
available from your local stove retailer.
The stove
must be fully cold and not be in use
before the stove is re painted.
Refer to the approved heat resistant spray paint manufacturer’s instructions.
This process is recommended to be carried out by an approved and competent stove installer such
as Hetas registered (England & Wales) or equivalent for other countries when the stove is being
serviced.
Summary of Contents for Windermere 5 SE
