New Leader L5034 G4, Assembly/Operators/Parts Manual

Page: 42 / 154

- 39 -
L5034G4
www.NewLeader.com
(800) 363-1771
305438-J
General Operating Procedures
1� Make sure unit has been properly serviced and is in good operating condition� It is highly recommended
to run the spreader prior to loading material to ensure acceptable operation�
2� Program controller with correct data for material(s) and application�
3� Adjust feedgate to appropriate setting�
4� Adjust spinner to give spread pattern desired� Calibrate and spread pattern test for any new material�
5� Fill applicable bins with material to be spread�
6� Engage hydraulics�
7� Begin spreading�
Drive only at speeds which permit secure control of vehicle! Failure to follow this requirement
may result in injury or machine damage�
Change hydraulic oil filter after first week (or not more than 50 hours) of operation on a unit.
*Visit
newleader�highwayequipment�com/calculators/yield-output
for interactive tools to calculate yield,
proper feedgate opening, conveyor revolutions per minute and mph to maximize the performance of your
spreader�