NETGEAR FSM726 - ProSafe Managed Switch, Setup Manual

Page: 124 / 156

700 Series Software Manual v2.1
6-32 Command Line Interface
Warning : The previous image in non-volatile memory will be lost when the procedure
completes.
• Last Saved option
The system will boot from non-volatile memory. This option will automatically show up after
the ‘Net & save’ option is selected and the unit is reset.
Syntax
FSM726(config)# system firmware boot [net-tftp | net-and-save | last saved]
Firmware TFTP-IP
The
Firmware TFTP-IP
command is used to specify the IP location of the TFTP server where
the new software image is stored.
Syntax
FSM726(config)# System firmware tftp-ip <IP address>
Where
<IP address>
= the IP address of the TFTP server where the new firmware image is stored.
Firmware TFTP-File
The
Firmware TFTP-File
command is used to specify the path and the filename of the new
firmware image.
Syntax
FSM726(config)# System firmware tftp-file <path&filename>
Where
<path&filename>
= the path and the filename of the new firmware image
RADIUS
For enhanced security, you can choose to have authentication done through the RADIUS server if
one is present on your network.
• Authen-Mode
The
authen-mode
command configures the method in which the user is authenticated.