NETGEAR FSM726 - ProSafe Managed Switch, Setup Manual

Page: 121 / 156

700 Series Software Manual v2.1
Command Line Interface 6-29
IP-filter address
The
IP-filter address
allows you to enter and remove IP address from the approved list. Use
the No command to remove an IP address.
Syntax
FSM726(config)# system ip-filter address <IP-address>
Where
<IP address>
= an IP address that is authorized to access the management.
IP-Mode
The
I
P-Mode
command sets the IP assignment mode of the switch. There are three modes
available to the user.
Manual – The user manually enter IP related information
BootP – Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from
a BootP server on the network
DHCP – The switch accepts DHCP broadcast from a DHCP server and automatically configure IP
related information
Syntax
FSM726(config)# system ip-mode [manual | bootp | DHCP]
Mask
Use the
Mask
command to set the network mask.
Syntax
FSM726(config)# system mask <network mask>
Where
<network mask>
= network mask of your network
Gateway
Use the
Gateway
command to set the default gateway