NETGEAR FS728TP - ProSafe 24 Port 10/100 Smart Switch, Software Administration Manual

Page: 186 / 261

186 | Chapter 5: Managing Device Security
FS728TP Smart Switch Software Administration Manual
To configure IP ACL interface bindings:
1.
Select an existing IP ACL from the ACL ID menu.
The packet filtering direction for ACL is Inbound, which means the IP ACL rules are
applied to traffic entering the port.
2.
Specify an optional sequence number to indicate the order of this access list relative to other
access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
3.
Click the appropriate orange bar to expose the available ports or LAGs.
•
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
•
To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
4.
Click
Cancel
to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5.
Click
Apply
to save any changes to the running configuration.