|
AlphaDisc CLD user guide V2.0
5
Electricity
Electric wiring must be performed by an authorized electrician only, using standardized and approved
components.
The filter should be installed in a manner in which the controller’s electrical components are protected from direct
contact with water.
When using external power, a 1A external fuse and minimum 22AWG wires are required.
1.3 COMMISSIONING
Carefully read this manual prior to operating the controller.
In order to achieve maximum performance and smooth operation of the controller, performing the start-up and
first operation procedures exactly as described in this manual is crucial.
1.4
OPERATION AND CONTROL
Do not operate the controller before carefully reading and becoming familiar with its operation instructions.
Observe the safety stickers on the controller and do not perform any operation other than those given in this
manual.
Do not operate or use the controller for purposes other than its original design.
The system is for use for non-hazardous liquids only!
Do not carry out system cleaning and/or maintenance in an explosive atmosphere.
1.5
BEFORE ANY MAINTENANCE OR NON-STANDARD OPERATION
Servicing the controller should be done only by technicians authorized by the manufacturer.
Do not carry out system cleaning and/or maintenance in an explosive atmosphere.
Disconnect the controller and the filter from the power supply and lock the main power switch.
1.6
PREVENTING DAMAGE DUE TO FROST
Non-operating periods:
To avoid damage or breakage when temperatures drop, command tubes must be disconnected and drained prior
to non-operating periods.
Operating season:
Your AlphaDisc™ CLD controller is equipped with a built-in feature that detects low temperatures and increases
the number of flushes to avoid freezing of water. You can activate and adjust the settings of this feature in your
Settings menu.
