Net2Phone MAX IP10 User Guide
11
2) Lift handset.
3) Dial destination phone number.
4) MAX IP10 attempts to connect the call through the analog phone line.
5) You will hear ringback tone.
6) When called party answers, you can begin speaking.
7) When the call is over, hang up.
3.2. Answering an incoming call from analog phone line
If the phone is ringing, then lift handset or press [SPEAKER] key to start speaking.
3.3. Redialing
When you want to make an analog phone call with the last dialed number in analog phone
mode, follow these steps:
1) Press the [PSTN] key to switch to analog phone mode. You will see screen like Figure 3 -1 on
the LCD.
2) Lift handset or press [SPEAKER] key.
3) Press the [REDIAL] key to dial the last dialed number.
4) MAX IP10 attempts to connect the call through the analog phone line.
5) You will hear ringback tone.
6) When called party answers, you can begin speaking.
7) When the call is over, hang up.
*** Note: Last dialed number is erased when the analog phone cable is disconnected.
3.4. Hook-Flash / Ring Volume / Ring Type
When you want to send hook-flash signal while holding the handset, press the [MEMORY] key.
When the phone is ringing, you can adjust the ring volume using [5] ~ [8] keys. [5] is for the
lowest volume and [8] is for the highest volume.
*** Ring volume is set to default when the analog phone line is disconnected.
When the phone is ringing, you can change the ring melody type using [1] ~ [4] keys.
*** Ring melody type is set to default when the analog phone line is disconnected.
