19/33
SI 72
When the system is equipped with the IntelliDeck
TM
option,
the number of documents can be set between 0 and 9.
If the IntelliDeck
TM
option is not available the number of
documents can be set to 0 or 1.
A feeder can be deselected when the amount of documents
is set to zero.
The default setting is 1 document per feeder.
When a feeder is set to daily mail the number of
documents is always 1 and can not be set in this screen
.
6.2.2 Document size
When document size is selected, the display shows the
screen as shown in fig. 40. The following choices are
available:
• go to the hopper swap screen (key 1),
• select a higher feeder number (key 2),
• select a lower feeder number (key 3),
• increase the document size of the documents in the
selected feeder (key 4),
• decrease the document size of the documents in the
selected feeder (key 5),
• confirm the settings by pressing (key 6) which will get
you back to the “job settings” menu.
The document size can be set between 90 mm
(3.54 inch) and 356 mm (14 inch) in steps of 1 mm (0.04
inch).
The default document size setting of a new job is 297 mm
(11.7 inch).
The position of the document stoppers is set by service
personnel according to the document sizes programmed in
the jobs.
Fig. 40
6.2.3 Hopper swap
When hopper swap is selected, the display shows the
screen as shown in fig. 41. The following choices are
available:
• go to the daily mail screen or when this is not available
to the “number of sheets” screen (key 1),
• select the pair of feeders which must be linked (key 2 or
3),
• select linked or unlinked for a pair of feeders (key 4),
• confirm the settings by pressing “OK” (key 6) which
will get you back to the “job settings” menu.
When a pair of feeders is linked, the settings of the
lowermost feeder will be shown in the display.
Fig. 41
Key
Key