SI 72
12/33
4.12 Counters menu
After pressing key 4 in the “main menu (1)”, the display
shows the “counters” menu (fig. 23). The “counters” menu
shows the following functions:
• reset the daily counter and stopcounter to zero (key 2),
• decrease the preset counter (key 3),
• increase the preset counter (key 4),
• save the counter settings with “OK” (key 6) which will
get you back to the “main menu (1)”.
The stopcounter is switched off when it is set to zero. The
display will show “Stop at off”.
The stopcounter can be set between 0 (switched off) and
9999.
Fig. 23
4.13 Inserting menu
When the start key is pressed the machine starts inserting
in automatic mode. The display shows the “inserting” menu
(fig. 24).
Press key 1 in the “inserting” menu for job information.
Return to the “inserting” menu by pressing key 6.
Fig. 24
4.14 Load "N Go
TM
menu
When the system is equipped with the Load “N Go
TM
function this will be displayed in the “main menu (1)” After
pressing key 5 in the “main menu (1)”, the
“Load “N Go
TM
” menu is displayed (fig. 25).
The Load "N Go
TM
function can be used for creating simple
jobs. The machine automatically recognizes the document
size, envelope size and necessary fold settings.
The adjustment of the envelope feed must be made to
obtain correct operation (see page 10).
When special feeders are selected the adjustment of the
document hoppers must be made (see pages 7 through 8).
The document will be folded and inserted in the envelope.
Only the address position can be adjusted if needed.
Testset run
Press key 3 to start a testset run (fig. 25). The machine
prepares a job 0 which is named “Load "N Go
TM
”.
Only the feeders that feed successfully will be selected.
When feeders are fitted with the double feed control
option, this will be selected automatically.
Fig. 25
Key
Key
Key
