SECTION 2
SETTING UP THE SYSTEM
28
USER GUIDE
Adjusting the Horizontal Print Position
The horizontal print position is adjusted via your software program. This is normally done by
changing the left margin or the location of the text box, in the layout.
Adjusting the Vertical Print Position
The vertical print position is adjusted by moving the print units. Loosen the thumb screw that
secures the print unit to the shaft. Then slide the print unit to the desired position and secure the
thumb screw. The red label, located at the inside of each print unit, identifies the approximate
print area for each of the print units. See “Head Layouts” on next page.
XPS-ProMail 3.0
Print
Area
Summary of Contents for RENA XPS-ProMail 3.0
