![background image](http://html2.mh-extra.com/html/nelson/n1500i/n1500i_operation-and-service-manual_3933346081.webp)
82
Tucker GmbH,
Mail / Post:
Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N1500i
As of: Aug 12.2021
Manual part number: BE 1221
6.16
Chuck Change Indicator
A user programmable weld counter counts down and turns the chuck change
indicator ON when it reaches zero.
Refer to F29 code in Section 4 Operation Fuction Codes and Error Codes.
Light will display
when the chuck is
at the recommended
time to change.
6.17
Configuring the stud feed interface to act as a ‘Weld
Complete’ signal
•
Use v1.06 firmware or later
•
Make F12 = ON
•
Make F54 = OFF
•
One time only: Before powering on unit, press and hold the fol- lowing buttons: I/t
mode, ‘1’, ‘5’ and ‘0’ through boot-up. If dis- play reads ‘OFF’, release keys, turn
power off and do procedure again. Otherwise, it reads ‘ON’ and unit is configured
appropri- ately. Doing this configures it to
not
give the output signal if
any
errors or
warnings occur.
•
Use F36 to enable\disable the output signal from the weld monitor results. ‘OFF’
to give the signal regardless of the weld monitor result. ‘ON’ to get the signal only
when a good weld, no signal on failed weld according to the weld monitor.