Stud welding unit N1500i
As of: Aug 12.2021
Manual part number: BE 1221
48
Tucker GmbH,
Mail / Post:
Max-Eyth-Str.1, 35394 Gießen, Germany
Note!
If welding on one workpiece with several welding units cannot be
avoided, it is not recommended to weld simultaneously
6.2 Basic Procedure
The process to begin welding using a Nelweld unit is very easy, once the proper
electrical connections and gun connections are established:
•
Turn the main power switch on the front of the unit to the “on” position. Wait for
the unit to complete its startup sequence.
•
Set the desired current and time settings using one of the following 3 methods:
1. Push Time/Current Mode button (1 in the Front Panel section), and up/down
buttons (4) to adjust time and current discretely.
2. Push Stud Expert (TM) Mode button (2 in the Front Panel section), and up/down
buttons (4) to adjust stud diameter and weld position (or another process
condition) and the welder automatically sets the weld current and time using a
database.
3. Push one of the 10 preset buttons (5 in the Front Panel section) to choose one of
the factory presets (see next section factory preset table).
•
Save any set points, if desired.
•
Adjust other settings by accessing the proper function.
•
Perform a lift check to verify proper gun lift.
•
Lock the unit, if desired.
•
Perform test welds to verify the correct welding settings.
•
After establishing proper setup, production welding may begin.
6.3 Weld Parameters
You can program this unit in 2 ways:
•
directly setting the current and time values
•
or use the Stud Expert (TM) mode based on stud diameter
