15 NED
XCM
4085TLCT6
UME-0062-01
ＰＣ
Ｃａｍｅｒａ Ｌｉｎｋ
Base or Medium or Full 対応
フレームグラバボード
カラーラインスキャンカメラ
ＸＣＭ４０８５ＴＬＣＴ６
Ｃａｍｅｒａ Ｌｉｎｋケーブル(SDR-MDR)
３Ｍ製 1MF26-L560-00C-xxx
電源ケーブル
DGPSH-10
カメラ用電源
ＤＣ＋１２Ｖ ３０Ｗ
CL2
CL1
CL2
CL1
3. Hardware
3.1 Camera Connection
Use the camera in the following way:
①
Camera Link cables must be used to connect the camera unit with the frame
grabber board.
Notes:
1)
When using 2 taps at each colour or 10-bit, two Camera Link cables are
required. The cables should be of the same length and from the same
manufacturer.
2) When using 1 tap at each colour with 8-bit, one Camera Link cable is used
.
Connect the cable to the CL1 connector (CL2 is unused).
3) Use asymmetric Camera Link cables and connect the camera with the
connector labeled as
”Camera side”.
4) A Medium and Full Configuration-compatible frame grabber has 2 connectors.
Check the specification of your frame grabber before connecting.
②
Connect the camera with the designated power supply.
Notes:
Use the designated power cable to connect the camera with the power source for
the camera. Insert the plug end of the cable into the camera. Attach the opposite
end (loose wires) to the power unit. Other than those above, a personal
computer, a frame grabber board, a compatible lens, a lens mount, a light source
and an encoder are necessary, depending on the situation.
Figure 3-1-1 Connections between Camera and Frame Grabber Board and Power Supply
Colour Line Scan Camera
Camera Link Cable (SDR-MDR)
3M:1MF26-L560-00C-xxx
Camera Link
Base, Medium or Full
Configuration
Frame Grabber Board
Power Cable
Camera Power Supply
