17
Connecting the AC Adaptor
Connect the AC adaptor as instructed below:
1. Connect the AC adaptor cable into the power port on the notebook.
2. Plug one end of the power cable into the adaptor.
3. Connect the power cable to a grounded 100- or 240-volt, 50- or 60-Hz AC power outlet.
CAUTION
•
Do not cover or place objects on the AC adaptor. Keeping the adaptor clear of
objects to let the adaptor cool properly during use.
•
Only use the AC adaptor that came with your notebook. Although other adaptors
may look similar, using them can damage your notebook.
CAUTION
This equipment uses an ungrounded power cable. Replace the cord if it becomes
damaged. The cord must be rated at least 250VAC at 10 amps, and must bear the
international safety agency approval. The plug must be appropriate for the country it
is used in. Check with your local dealer for the HAR (Harmonisation certification
mark) type 18 AWG (American Wire Gauge), 2 conductor cord, or better. Obtain
replacement cords from an authorised service centre. The replacement must be of
the same type and have the same voltage rating as of the original cord.
Using the Battery
Note
Although the battery was fully charged at the factory, transit and shelf time may
have had reduced the initial battery charge. We recommend that when you use your
notebook for the first time, to connect it to the AC power using the AC adaptor. This
will also recharge your battery.
When the battery capacity is low, always respond by immediately saving your data, and
connecting your notebook to the AC adaptor. If an AC adaptor is not available, change the
battery using the battery replacement procedure.
For more information, please refer to:
Introducing Your NEC VERSA
→
Replacing the
Battery
in this Electronic User Guide.
If you do not take any action, the notebook will automatically go into Hibernation (Save To
File) mode.
