Adding Options 4-13
Follow the instructions in the next section to prepare your drive for installa-
tion in the docking station.
Preparing the Drive
Read the documentation that came with the drive before beginning the in-
stallation procedure. Set any switches that need to be set on the drive.
If your drive comes with locking rails, do not use them. If the drive has
locking rails attached, remove them.
Installing Drives in the Front Bay
Use the following procedure to install a half-height diskette, tape, CD-ROM
or hard disk drive in the front drive bay. See “Preparing the Hard Disk
Drive” later in this chapter for hard disk drive preparation instructions.
Drive installation involves three basic procedures:
n
Removing the drive cage.
n
Attaching the drive(s) to the drive cage.
n
Attaching power and signal cables to the drive.
n
Finishing up (reinstalling the drive cage with the drive in the docking
station).
These procedures are described next.
Removing the Drive Cage
Prepare the docking station for drive installation by removing the drive cage
as follows.
WARNING
Make sure docking station power is off, the NEC Versa is not
docked, peripheral devices are disconnected, and cables are de-
tached from the docking station before beginning installation proce-
dures.
1.
Remove the docking station cover as described in “Cover Removal.”
Summary of Contents for VERSA DOCKING STATION 6000
Page 7: ...vi Contents ...
