Installing Options and Connecting Devices 4-3
Installing Devices in the File Bays
The NEC Versa Dock has two 5.25-inch half-height bays for installing
optional devices. The bay located on the right front of the NEC Versa
Dock (the side closest to the keylock), supports the installation of an
optional VersaBay III Adapter Kit. Installing the Adapter Kit transforms
the bay into a VersaBay III. You can then use your optional VersaBay III
devices in the NEC Versa Dock.
Installing devices in the file bays involves the following procedures:
!
Removing the NEC Versa Dock docking tray, front panel, and cable
cover.
!
Disconnecting the cables from the motherboard.
!
Connecting the cables to the device.
!
Installing the device in the NEC Versa Dock.
!
Reconnecting the cables to the motherboard.
!
Replacing the NEC Versa Dock cable cover, front panel, and docking
tray.
Use the instructions in the sections that follow to install an IDE device in
a file bay and to install the optional VersaBay III Adapter Kit.
Removing Trays, Panels, and Covers
Before installing a device in one of the NEC Versa Dock file bays, you
must remove the docking tray, front panel, and cable cover. Do so as
follows:
1.
Unplug the NEC Versa Dock, disconnect any peripheral devices that
are attached, and undock the NEC Versa if it is docked.
2.
Disconnect any external cables that might be attached on an installed
PCI board (such as a network board).
3.
Turn the keylock switch to the Manual position to disengage the
motor mechanism.
