4-44 Using Your NEC Versa
8.
Reassemble the NEC Versa as follows.
Lower the palm rest and slide it back into place.
Turn the system over and replace the two screws.
9.
Your system is now ready for the BIOS update or Pass-
word change. Continue to the next section to update the
BIOS. See Chapter 3, “Using Setup,” for details about
changing your password.
Performing the BIOS Update
If you made any changes through the Setup utility, you may
want to jot them down. When you update the BIOS, any
customized settings you made are lost. After completing the
BIOS update, you can then use your notes to reset them to
your preferences.
Use the following procedure to perform the BIOS update.
1.
Make sure that the system is plugged into the AC
adapter and AC power and that system power is off.
NOTE
Your system must be connected to AC power
to perform the BIOS update.
2.
Insert the BIOS Update diskette into the diskette drive.
3.
Power on the system with the diskette in the diskette
drive. The system boots and automatically loads the
utility. A message appears on the screen. Be sure to read
the message and follow all instructions.
4.
Press any key to continue.
