NEC Univerge UM8000, Installation Manual

Page: 57 / 130

Installation Manual 8 - 1
Setting Up Inte
g
ra
tion (SV8300)
8
Setting Up Integration (SV8300)
S
ECTION
1
O
VERVIEW
This chapter describes setup and programming for integrating the SV8300
telephone system and the voice messaging system.
S
ECTION
2
S
ETTING
U
P
I
NTEGRATION
Several tasks are required to integrate UM8000 with the phone system.
Use the phone system programming interface (either a CAT phone or a
SV8300 PCPro) to enter the phone system programming commands
below.
Follow all the procedures in this section in the order presented.
2.1 Assign Extension Numbers to Voice Messaging Ports
Assign extension numbers to the voice messaging ports. The
UM8000 blade occupies ports AABB01 to AABB08 for an 8-port
system, and ports AABB01 to AABB16 for a 16-port system.
2.2 Enabling Digital Voice Messaging Support
1. Enable AAInfo for incoming calls.
Command Code: 1000
First Data: AABBXX
Where AA = Chassis,
BB = Slot,
XX = Port.
Second Data: Fxxx
Where F specifies a digital extension and
< xxx > is the voice messaging port extension
number.
NOTE
Repeat this command for each port on the UM8000 blade.
Command Code: 08
First Data: 702
Second Data: 0