NEC UNIVERGE SL2100, Networking Manual

Page: 23 / 196

S
ECTION
4 HOW TO EXIT PROGRAMMING MODE
To exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1.
Press Mute key to exit the program options, if needed.
Program Mode
Hybrid (4W) Multiline Terminal
Program Mode
Base Service OP1 OP2
IP Multiline Terminal
2. Press Speaker . If changes were to the system programming, "Saving System Data" is displayed.
3. The display shows "Complete Data Save" when completed and exits the telephone to an idle
mode.
To save a customer’s database, a blank SD Card is required. Insert the SD Card into the CPU and, using
Program 90-03, save the software to the SD Card. (Program 90-04 is used to reload the customer data if
necessary.) Note that a SD Card can only hold one customer database. Each database to be saved requires
a separate drive.
CPU board
Blank SD Card
SD slot (J12)
S
ECTION
5 USING KEYS TO MOVE AROUND IN THE PROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter data, edit data and
move around in the menus.
Table 5-1 Keys for Entering Data (Hybrid (4W) Multiline Terminal)
When you want to ... Telephone Programming
Enter Data into program 0 ~ 9,
*
, #, Line Key (1 ~ 6)
Next Index Cursor Key (Up)
ISSUE 1.0 SL2100
Networking Manual 5-3