NEC UNIVERGE SL2100, Networking Manual

Page: 159 / 196

Program
Number
Program Name Description/Comments Assigned Data Level
1 2 3
10-12-10 CPU Network Setup – Subnet
Mask Define the Media Gateway Sub-
net Mask Address. 128.0.0.0
192.0.0.0
224.0.0.0
240.0.0.0
248.0.0.0
252.0.0.0
254.0.0.0
255.0.0.0
255.128.0.0
255.192.0.0
255.224.0.0
255.240.0.0
255.248.0.0
255.252.0.0
255.254.0.0
255.255.0.0
255.255.128.0
255.255.192.0
255.255.224.0
255.255.240.0
255.255.248.0
255.255.252.0
255.255.254.0
255.255.255.0
255.255.255.128
255.255.255.192
255.255.255.224
255.255.255.240
255.255.255.248
255.255.255.252
255.255.255.254
255.255.255.255
(default = 255.255.0.0) ✓
10-46-06 Register Port
Assign the port number to which
the SIP messages are sent to on
the VoIPDB. This same port num-
ber must be assigned in the SIP
Multiline terminals. If this com-
mand is changed, it requires a
CPU reset. 0~65535 5080
✓
10-46-13 Subscribe Session Port 0~65535 5081 ✓
10-46-14 NAT Mode Turns On/Off the NAT mode of the
system. 0 = Off
1 = On
Default = Off
✓
15-05-45 NAT Plug&Play Effective when PRG 10-46-14 is
set to NAT Mode. Select sending
RTP port number to remote rout-
er, use from negotiation result (0)
or received RTP packet (1). 0 = Off
1 = On
Default = Off
✓
15-05-47 IP Telephone Terminal Basic Data
Setup - Registration Expire Timer
for NAT On a per station basis, this setting
defines the SIP registration expiry
timer. This setting only applies to
8IPLD stations connected via
NAPT. If this value is set to 0, for
a NAPT terminal, the value in
PRG 84-23-01 is applied. 0 = Disable
60 ~ 65535 (sec)
Default = 180
✓
15-05-48 IP Telephone Terminal Basic Data
Setup - Subscriber Expire Timer
for NAPT On a per station basis, this setting
defines the SIP subscribe expiry
timer. This setting only applies to
8IPLD stations connected via
NAPT. If this value is set to 0, for
a NAPT terminal, the value in
PRG 84-23-02 is applied. 0 = Disable
60 ~ 65535 (sec)
Default = 180 ✓
ISSUE 1.0 SL2100
Networking Manual 11-5