NEC QX-S5500G Series, Installation Manual

Page: 41 / 161

Installation Guide
QX-S5500G Series Ethernet Switches 3. Installing the switch
3-19
Figure 3-21 Power cord Specifications
Connector(on the Device Side) Cable Ratings Cable Length Plug(Power Facility)
IEC-320-C13
125V, 10A
Comply the standard of
each country
Comply the standard of
each country
IEC-320-C13
250V, 10A
Comply the standard of
each country
Comply the standard of
each country

The DC power cord isn't attached to switch. The DC power cord has to be prepared by a user. see “ Making
of DC power cord ”.

When using QX-PS800-T2, please prepare connected DC power cord to QX-PS800-T2. supplied DC
power cord is attached to QX-PS800-T2.

NOTE:

The power cord isn't attached to switch. The power cord has to be prepared by a user.

There is a possibility that a Power Cable Holder can't be used for a power cord, depending on the kind of
power cord.
3.7.1 Connecting a AC power cord to the switch
To connect an AC power cord to the QX-S5524GT-4X2Q or QX-S5548GT-4X2Q that uses
fixed power modules:
1) Wear an ESD wrist strap and make sure it makes good skin contact and is correctly
grounded.
2) Attach the hooks of the bail latch into the holes on the two sides of the AC-input power
receptacle, and pull the bail latch upwards (see Figure 3-22).
3) Connect one end of the AC power cord to the AC-input power receptacle on the switch
(see callout 1 in Figure 3-23).
4) Pull the bail latch down to secure the plug to the power receptacle (see callout 2 in
Figure 3-23).
5) Connect the other end of the power cord to the AC power outlet.