Installation Guide
QX-S5500G Series Ethernet Switches
3-27
1) Wear an ESD wrist strap and make sure it makes good skin contact and is correctly
grounded.
2) Remove the mounting screws on the filler panel over the interface card slot with a
Phillips screwdriver and remove the filler panel. Keep the filler panel for future use.
Put a flat screwdriver in central prominence of a filler panel, please so as not to
damage. And remove a filler panel. Please keep a filler panel in the purpose when
using it next time.
Figure 3-33
Removing the filler panel over an interface card slot
2
1
3) Unpack the interface card.
4) (Optional.) If the interface card has an ejector lever, rotate out the ejector lever. Skip
this step if the interface card does not have an ejector lever.
5) Gently push the interface card in along the guide rails until the interface card has good
contact with the switch chassis
6) (Optional.) If the interface card has an ejector lever, rotate in the ejector lever. Skip this
step if the interface card does not have an ejector lever.
7) Tighten the captive screws with a Phillips screwdriver to secure the interface card in
the slot.