Disassembly and Reassembly 3-9
AGP Board Removal
Remove the AGP board as follows.
1.
Remove the left side cover (see “Removing the Left Side Cover” earlier in
this section).
2.
Remove the screw holding the AGP board in its expansion slot.
3.
Pull the AGP board out of its connector on the system board and out of the
system.
4.
If not replacing the AGP board, install the previously removed slot cover.
Front Panel Removal
Remove the front panel from the chassis as follows.
1.
Remove the left side cover (see “Removing the Left Side Cover” earlier in
this section).
2.
Remove the front panel from the chassis by grasping the edges at the bottom
of the panel and evenly pulling out on the panel until its locking plugs
release.
Removing the Front Panel
A – Metal Shield
C – Front Panel
B – Plugs
Summary of Contents for PowerMate VT 300i Series
