NEC PowerMate VT 300i Series, Service And Reference Manual

Page: 148 / 190

A-4 NEC PowerMate VT 300i Series Release Notes
2.
Double click the Network icon in the Control Panel window.
3.
Click the
Protocols
tab. In the Protocols display, the following protocols
are loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4. Highlight
NWLink IPXSPX-Compatible Transport
and click
Remove
. A
warning window appears asking for confirmation to continue.
5.
Click Yes . The NWLink IPXSPX-Compatible Transport and NWLink
NetBIOS lines disappear from the Protocols display.
6.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
7.
Click Add . The Select Network Protocol window appears.
8.
Highlight TCP/IP Protocol and click OK . The TCP/IP Setup window
appears. If there is a DHCP server on the network, click Yes ; otherwise
click
No
.
9. Change the path in the window to
C:\I386
. Click
Continue
. The Network
window appears. If Yes was clicked in step 8, skip to step 16. If No was
clicked in step 8, the Windows Setup window appears.
10.
Click Close . The Microsoft TCP/IP Properties Box appears.
11.
Fill in the IP Address , the Subnet Mask , and the Default Gateway in the
“Specify an IP address” area.
12. Click the
DNS
tab and enter the host and domain name in the DNS display.
13. Click the
Identification
tab and change the Computer Name if appropriate.
14. Click the
WINS
tab and enter the WINS address if appropriate.
15. Click the
Routing
tab and enable IP forwarding if appropriate.
16. Click
OK
. When prompted to restart the system, click
Yes
.
Installing Cheyenne Backup
After installing the Cheyenne
®
Backup utility on the system and rebooting the
system, an “Unable to connect to Group” error message is displayed. This
message indicates that a backup tape unit is not installed. Installing a tape unit
or reconfiguring the Cheyenne Backup utility removes this message.
See “Using Cheyenne Backup” for issues related to using the utility in
Windows 95.