3-6 Disassembly and Reassembly
Removing the Right Side Cover
Remove the right side cover as follows.
!
WARNING
Before removing the right side cover, turn off the power and
unplug the system power cable. Power is removed only
when the power cable is unplugged.
1.
Turn off and unplug the system unit.
2.
Unplug the keyboard, mouse, monitor, and any other device (such as a
printer) connected to the back of the system.
3.
Remove the left side cover as previously described.
4.
Remove the three screws holding the right side cover to the rear of the
chassis.
5.
Grasp the handle on the right side cover and slide the cover towards the rear
of the chassis about one-half inch.
Removing the Right Side Cover
A – Screws
C – Right Side Cover
B – Handle
6.
Pull out the bottom of the cover and tilt the cover towards the left side of the
chassis until it releases from the chassis.
7.
Remove the cover from the chassis.
Summary of Contents for PowerMate VT 300i Series
