3-4 Disassembly and Reassembly
Removing the Left Side Cover
A – Left Side Cover
C – Handle
B – Thumb Screws
D – Lock Tab
Replacing the Left Side Cover
Replace the left side cover as follows.
Note
:
To prevent damage to system cables, carefully
position the cables out of the path of the cover.
1.
Position the left side cover over the side of the chassis so that the back edge
of the cover is about an inch beyond the back edge of the chassis (see the
following figure).
2.
Fit the flange on the bottom of the cover over the rail along the bottom edge
of the chassis.
3.
Align the lock tab slot at the bottom rear of the cover with the lock tab.
4.
Align the tabs on the top of the cover with the top slots on the chassis.
5.
Firmly press the cover against the chassis and slide the cover towards the
front of the chassis until it locks in place.
Note
:
If the left side cover does not slide all the way to
the front of the chassis, check that the cover tabs at the front
of the cover are properly inserted into their slots in the
chassis.
Summary of Contents for PowerMate VT 300i Series
