Setting System Board Jumpers 5-9
DENYING ACCESS TO SETUP
In special cases, you may want to deny the user access to
the Setup utility. In this case you must change the jumper
from its default position. Use the following procedure to
change the jumper setting.
1.
Power off the system and unplug any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see “Removing the
Desktop Cover” or “Removing the Minitower Cover” in
Chapter 3).
3.
Locate the Setup Access jumper J1K2 (B) on the system
board (see the figure “Locating system configuration
jumpers”).
4.
You may have to remove any installed expansion boards
to access the jumpers (see “Removing Expansion
Boards” in Chapter 3).
5.
Move the jumper block to the Access Denied position
(see the following figure).