34
7
Repeat steps
4
to
6
for the other CRTs if necessary.
8
To end this adjustment, press the END button.
• Whenever the END button is pressed, the menu will sequence
in this order:
“FOCUS” menu
→
“ADJUST” menu
→
Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR
or
button to select either “YES” or “NO” and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode the next
time, you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode the next
time, you will not need to re-enter your passcode.
NOTE: The center focus for the Blue CRT is pre-adjusted so that
the best white uniformity can be obtained at the gauge center
(0%). For this reason, it has been set at the factory to be
slightly out of focus.
Therefore you should not perform the center focus adjustment
to the Blue CRT with the remote control.
m
ASTIG Adjustment
When ASTIG ADJUSTMENT in the OPTION menu is set to
ON, the focus menu is displayed.
Holding down CTL and then pressing FOCUS toggle between
the ASTIG CROSS and the ASTIG CORNER mode
To adjust ASTIG CROSS/CORNER:
1) Hold down CTL, then press FOCUS to select either ASTIG
CROSS or ASTIG CORNER.
First perform the ASTIG CROSS adjustment and then the
ASTIG CORNER adjustment.
• The test pattern automatically changes to the DOT
COARSE pattern.
2) Select the CRT you wish to adjust with R or G button.
• The blue CRT is not adjusted.
3) Press the R or G button to project the only CRT beam to be
adjusted.
• You can turn on or off each CRT beam (R, G, and B)
ADJUSTMENT
– F O C U S –
1 / C E N T E R
2 / E D G E A L L
3 / A S T I G C R O S S
4 / A S T I G C O R N E R
R E T U R N U S E R M O D E ?
Y E S
N O
F O C U S
- A S T I G C R O S S -
C R T - R -
S C R E E N - U -
6 0 %
H V
S K
4 0 %
