2-2. Replacing this product
The following describes procedures to hot-swap a RAID controller in a dual RAID controller configuration.
a)
To replace a failed RAID controller:
1) Confirm that either of controller fault LEDs on rear of RAID controller is lit.
2) Shutdown the server connected to the failed RAID controller, and remove the SAS cable
connected to the failed RAID controller.
3) Remove the failed RAID controller when the disk array unit is turned on.
4) Wait for 60 seconds or more, and then install a new RAID controller.
5) Confirm that the both controller LEDs on the rear of RAID controller are lit
If they are not lit, remove and install the RAID controller again.
6) Confirm with the disk array unit’s management software that the operating system can recognize
the new RAID controller.
48
Summary of Contents for N8190-148
