2. Installing and Replacing This Product
Before you start installation or replacement, read the manual attached to the disk array unit.
· Connect this product only to the devices specified by NEC. Even if it is
possible to connect a non-specified device or a device that has a
non-standard interface, this product or the connected device will not operate
properly and may get damaged.
· For information on devices that can be connected, see manuals attached to
the devices or ask your sales representative from whom you purchased this
KEY
2-1. Installing this product
Follow the steps below to add this product to the disk array unit. Add this product before its setup.
1) Using two hands, grasp each latch between the thumb and forefinger of each hand. Squeeze thumb
and forefinger together to release the latch. Pull the latches outward.
Squeeze two ends of latch
together to release
Open Position
Closed Position
2) Grip the latch handles and withdraw the dummy controller panel.
44
Summary of Contents for N8190-148
