User Support
Before requesting repair
When you suspect failure, do the following.
1. Check if the power and signal cables are connected correctly.
2. Refer to the manuals which came with disk array unit and perform remedies for the phenomena or
error messages described there.
If the error remains after you perform the remedies above, do not try to do any more operation but contact
your dealer or local NEC maintenance service personnel.
When sending your unit for repair
When you send your unit for repair, prepare the following.
1. Note of error messages displayed on the display device
2. Fault
information
3. Record of the main unit and peripheral devices
20
Summary of Contents for N8190-148
