2. System BIOS Setup
Express5800/T110f-S User’s Guide
121
Chapter 3 Setup
2.4
Cases that Require Setting Changes
If you change the BIOS settings shown below, use the SETUP utility to change a parameter which was
configured as factory setting. A list of SETUP parameters and factory settings are described in
Chapter 2 (1.
Details of System BIOS) in "Maintenance Guide".
Category
Description
To be changed
Remark
Change date and time
Main
→
System Date
Main
→
System Time
Configurable on OS
On/Off NumLock on power ON
Boot
→
Bootup Numlock State
Basic
On/Off the function to display
the NEC logo during POST
Boot
→
Quite Boot
→
Disabled
By pressing the <Esc> key,
prevent the display of the logo.
Advanced
→
PCI Configuration
→
PCI
Device Controller and Option ROM
Settings
→
PCI Slot n Option ROM
→
Enabled
n
is PCI slot number of the
RAID Controller
Optional
board
When an optional board is
installed, set to [Disabled] for
Option ROM for all PCI devices
except for the boot device.
Advanced
→
PCI Configuration
→
PCI
Device Controller and Option ROM
Settings
→
LAN1 Option ROM Scan
→
Disabled
Option ROM on LAN1 must be
disabled.
Memory
Configure the memory after the
DIMM is added or exchanged.
Advanced
→
Memory Configuration
→
Memory Retest
→
Yes
After rebooting, the
Memory
Retest
setting changes to
No
automatically.
Change the boot order of
devices
Boot
→
Boot Option Priorities
→
Change the boot priority
Use remote power on function
(from modem)
Advanced
→
Advanced Chipset
Configuration
→
Wake On Ring
→
Enabled
Use remote power on function
(from RTC alarm)
Advanced
→
Advanced Chipset
Configuration
→
Wake On RTC Alarm
→
Enabled
Boot
Control from HW console
terminal
Advanced
→
Serial Port Configuration
→
Change respective setting.
Set a password to restrict
operation of the SETUP utility.
Security
→
Administrator Password
→
Security
→
User password
After a password is set, a
message prompting you to
enter the password is displayed
when the SETUP utility is
launched next time.
Security
Set a password to restrict
booting.
Security
→
Password on Boot
→
Enabled
You can select this parameter
after you set a password.