Windows Setup 4-47
Windows Server 2003
Installation
Follow the procedure below to install.
1.
Power on the system.
2.
Load the backup CD-ROM DISC 1 or the Windows Server 2003 R2 DISC 1 into the optical
disk drive.
3.
After loading the backup CD-ROM DISC 1 or the Windows Server 2003 R2 DISC 1 into the
optical disc drive, reset (Press
Ctrl
,
Alt
and
Del
), or power off to reboot the NEC
Express5800 series.
System launches from the CD-ROM, and NEC
EXPRESSBUILDER starts.
IMPORTANT:
When a bootable OS is already installed on the HDD, press
Enter
key while [Press any key
to boot from CD…] is appearing on the top of the screen. You do not need to operate this if
no bootable OS is installed.
If the Windows Setup screen does not appear after this operation, it means
Enter
key was
not pressed properly. Power on to restart the system and start from the beginning.
4.
Press
F6
key while either of the following messages appears on the screen.
On the top of the screen: [Setup is inspecting your computer’s configuration…]
On the bottom of the screen: [Press F6 if you need to install a third party SCSI or
RAID driver]
TIPS:
After pressing
F6
key, no change appears on the screen at this point.
If there is no need to press
F6
, proceed to the step 9.
