Windows Setup 4-63
IMPORTANT:
To perform this procedure, you need to log on as an administrator or a member of
administrator group.
RDR can only be set on the basic disk inserted into the built-in slot of NEC
Express5800/ft series. It cannot be set on the dynamic disk.
For the disk on which RDR is set, use the products with the same serial number.
Be sure to configure the RDR settings in the same way not only when the OS is
installed but also when the disk is added to the PCI module.
Create partitions only after the duplication of the hard disk drives are configured.
Dual disk configuration procedure differs depending on the procedure whether it is for the system
disk (slot 0) or the data disk (slot 1 to slot 7).
To configure the dual disk of the system disk, refer to “System Disk Dual Configuration Procedure.”
To configure the dual disk of the data disk, refer to “Data Disk Dual Configuration Procedure.”
System Disk Dual Configuration Procedure
Configure the dual disk of the system disk with the following procedure.
1.
Go to [Start]
−
[All
Programs]
−
[RDR]
−
[RDR Utility],
and start RDR
Utility.
On the left pane of
the RDR Utility,
select Slot 0 disk of
PCI Module 10 and
confirm that
“ConfigState” on
the right pane
shows “Boot,
Configured, Active,
Imported.”
