NEC Express5800/120Rc-2, Service Manual, Page: 109 / 194

Disassembly and Reassembly 4-33
Removable Media Devices
The illustration in Figure 4-36, A shows the standard system configuration. In
this configuration the CD-ROM and floppy diskette drive are installed in a
single peripheral bay (Bay 6). A hard disk drive may be install below the
CD-ROM and floppy diskette drive in Bay 5. To install an optional removable
media device in your system, the hard disk drive cage must be removed from
Bay 5 and the CD-ROM and floppy diskette drives installed in its place. This
configuration is shown in Figure 4-36, B. A variety of SCSI removable media
devices can be installed in this configuration. Contact your sales representative
or dealer for a list of approved removable media devices.
B
A
Bay 6
Bay 5
Bay 6
Bay 5
Figure 4-36. Removable Media Devices
If you are adding or removing a SCSI removable media device, consider the
following:
!
The optional SCSI tape drive address assignment is 2.
Reconfiguring your system to accommodate an optional removable media
device involves the following procedures.
!
Removing the CD-ROM/diskette drives from bay A of the system
!
Removing the hard disk drive cage from bay B of the system
!
Installing the CD-ROM/diskette drives into bay B of the system
!
Installing the removable media device into Bay A of the system.