NEC Express5800/120Rc-2, Service Manual, Page: 106 / 194

4-30 Disassembly and Reassembly
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
6. Record the drive model and serial numbers in the equipment log.
7.
Place the drive in the carrier, with its connector facing the rear of the carrier.
8.
Secure the drive in the carrier with the four screws supplied with the disk
drive. See Figure 4-32.
Figure 4-32. Securing the Drive in the Carrier
9.
Install the drive carrier with drive into the bay (Figure 4-33) as follows:
!
Open the drive carrier locking lever located on the left side of the carrier.
!
Align the drive carrier with the bay guide rails.
!
Slide the drive carrier into the bay until it docks with the SCSI backplane
connector. See Figure 4-33, B.
!
Press the carrier lever into its locked position so that it is flush with the
front of the carrier. See Figure 4-33, A.
10.
Plug in the server power cord, and power on the server.
11.
Slide the server into the system rack and secure it to the rack.
12.
Install and secure the front bezel following procedures described earlier in
this chapter.
Wrong Right
A
B
Figure 4-33. Installing a Disk Carrier into the Bay